Skip to content
FAQ Contact Order Tracking Affiliate
|<none>|4001294199137

iFlight iPower GM3506 Gimbal Motor w/ AS5048A Encoder

by iFlight
€0,00 - €0,00
€0,00
€69,99
€69,99 - €69,99
€69,99

free return

Do you live in Belgium or The Netherlands? Then you can return your package for free!

in stock, ready to be shipped

Description

What is encoder technology in brushless gimbal control system?
  • The 3-axis gimbal stabilization system that relies on both active motor-driven components and passive inertial stabilization. Passive stabilization is based on the principles of inertia (the tendency of an object to resist change in its motion) and requires the camera to be well balanced in the Pan, Tilt and Roll axes. Active stabilization refers to the techniques of using sensors to measure the Pan, Tilt and Roll movements of the camera and counter these movements using motors attached to the 3 axes.

Characteristics
  • Easy to do gimbal tuning, no need to calibrate much anymore.
  • Energy saving, 5 times long working time than gimbal without encoder system.

Dual IMUs.
  • Faster response, motor torque increases instantly, no more bug for difficult turning angle.

Encoderchip AS5048A
  • GM3506 Gimbal-motor met encoder AS5048A
  • iPower Motors' GM35 Series Motor is the ultimate brushless gimbal motor for SLRs and cameras of similar weight. This motor is designed for large-scale multi-rotor platforms that want to lift an SLR-sized gear - 1.5 kg/cm torque. The principle of camera stabilization using direct drive brushless motors. In fact, the gimbal based on BLDC motors is very similar to the common gimbal based on hobby servo.
  • Encoders are special sensors that are added to each brushless motor of a Gimbal stabilizer, allowing the system to more accurately track motor position for greater stability, which in turn also increases battery efficiency.
Model GM3506
Motor Out Diameter Ф40±0.05mm
Motor Height 25.8±0.2mm (Including Encoder Housing)
Hollow Shaft(OD) F12-0.008/-0.012 mm
Hollow Shaft(ID) F8.6+0.05/0 mm
Wire Length 610±3mm
Cable AWG #24
Motor Weight 72±0.2g
Wire plug 2.5mm dupont-connector
No-load current 16V
No-load volts 0.17±0.05 A
No-load Rpm 2149~2375 RPM
Load current 12V
Load volts 1A
Load torque(g) 600-1000
Motor internal resistance 5.6Ω±5% (Resistance varies with temperature)
High voltage test DC500V 1mA @2sec
Rotor housing runout ≤0.1mm
Steering (axle extension) Clockwise
High-low temperature test
High temperature Keeps at 60℃ for 100 hours, then can work normally after 24 hours at room temperature
Low temperature Keeps at -20℃ for 100 hours, then can work normally after 24 hours at room temperature
Maximum power ≤25W
Working current 2-3S
Working temperature -20~60℃;10~90%RH