Skip to content
FAQ Contact Order Tracking Affiliate
|<none>|1005002940265680

iFlight iPower GM5208 Gimbal Motor w/AS5048A Encoder/Alexmos 32BIT BGC Set

by iFlight
Sold out
€0,00 - €0,00
€0,00
€589,99
€589,99 - €589,99
€589,99

free return

Do you live in Belgium or The Netherlands? Then you can return your package for free!

Out of stock
Description
Description
  • Encoders are special sensors that are added to each brushless motor of a Gimbal stabilizer, allowing the system to more accurately track motor position for greater stability, which in turn also increases battery efficiency.

What is encoder technology in brushless gimbal control system?
  • The 3-axis gimbal stabilization system that relies on both active motor-driven components and passive inertial stabilization. Passive stabilization is based on the principles of inertia (the tendency of an object to resist change in its motion) and requires the camera to be well balanced in the Pan, Tilt and Roll axes. Active stabilization refers to the techniques of using sensors to measure the Pan, Tilt and Roll movements of the camera and counter these movements using motors attached to the 3 axes.

Characteristics
  • Easy to do gimbal tuning, no need to calibrate much anymore.
  • Energy saving, 5 times long working time than gimbal without encoder system.
  • Dual IMUs.
  • Faster response, motor torque increases instantly, no more bug for difficult turning angle.
  • Encoderchip AS5048A
Model GM5208
Engine Outer Diameter Ф63±0.05mm
Car height 30.7±0.2mm (Including encoder housing)
Hollow shaft (OD) F15-0.008/-0.012mm
Hollow axis (ID) F12+0.05/0mm
Cable length 610±3mm
AWG cable #24
engine weight 209±0.5g
Wire connection 2.5mm dupont-connector
No-load current 20V
No-load voltage 0.09±0.1A
No-load speed 456~504RPM
Load current 20V
Load voltage 1A
Load torque (g) 1800-2500
Internal resistance of the motor 15.2Ω±5% (Resistance varies with temperature)
High voltage test DC500V 10mA @1sec
Rotor housing outlet ≤0.1mm
Steering direction (shaft extension) Clockwise
High-low temperature test
High temperature Store at 60℃ for 100 hours and the motor can work normally after 24 hours at room temperature
Low temperature Store at -20℃ for 100 hours and the motor can work normally after 24 hours at room temperature
Maximum power ≤40W
Working current 3-5S
Working temperature -20~60℃;10~90%RH

 

What is included

  • 3 x GM5208-12 gimbal motor with AS5048A encoder and magnet
  • 1 x Alexmos 32BIT BGC Board Encoder Version without Aluminum Case
  • 1x Set of connection cables