Skip to content
FAQ Contact Order Tracking Affiliate
|<none>|1005002926699199

iFlight iPower GM8112-80T Gimbal Motor w/ AS5048A Encoder/ Alexmos 32BIT BGC set

by iFlight
€0,00 - €0,00
€0,00
€816,99
€816,99 - €816,99
€816,99

free return

Do you live in Belgium or The Netherlands? Then you can return your package for free!

in stock, ready to be shipped

Description

Description
  • Encoders are special sensors that are added to each brushless motor of a Gimbal stabilizer, allowing the system to more accurately track motor position for greater stability, which in turn also increases battery efficiency.
  • What is encoder technology in brushless gimbal control system?
  • The 3-axis gimbal stabilization system that relies on both active motor-driven components and passive inertial stabilization. Passive stabilization is based on the principles of inertia (the tendency of an object to resist change in its motion) and requires the camera to be well balanced in the Pan, Tilt and Roll axes. Active stabilization refers to the techniques of using sensors to measure the Pan, Tilt and Roll movements of the camera and counter these movements using motors attached to the 3 axes.

Functions
  • Easy to do gimbal tuning, no need to calibrate much anymore.
  • Energy saving, 5 times long working time than gimbal without encoder system.
  • Dual IMUs.
  • Faster response, motor torque increases instantly, no more bug for difficult turning angle.
  • Encoderchip A5048a

iPower cardanische motor GM8112
  • The GM8112 motor from iPower Motors is the ultimate brushless gimbal motor for Red Epic / Large Cameras. This motor is designed for large-scale multi-rotor platforms that want to lift Red Epic and DSLR sized gears - 6 kg/cm of torque. The principle of camera stabilization using direct drive brushless motors. In fact, the gimbal based on BLDC motors is very similar to the common gimbal based on hobby servo.
Model GM8112
Engine outer diameter Ф89,5±0,05 mm
Car height 33.4±0.2 mm (including encoder housing)
Hollow shaft (OD) Ф25-0,008/-0,012 mm
Hollow axis (ID) Ф22+0,05/+0,1 mm
Wire length 610±3 mm
AWG cable #24
weight engine 446±1 g
Wire connector 2,5 mm dupont-connector
No load current 22 V
No load voltage 0,3±0,1 A
No load Rpm 380~420 RPM
Load current 20 V
Load voltage 2 A
Load torque (g) 6000-9000
Internal motor resistance 4.2Ω±5% (resistance varies with temperature)
High voltage test DC500V 1mA @2 sec
Rotor housing outlet ≤0,1 mm
Steering (shaft extension) clockwise
High-low temperature test
High temperature Keep at 60℃ for 100 hours and the motor can work normally after 24 hours at room temperature
Low temperature Keep at -20℃ for 100 hours and the motor can work normally after 24 hours at room temperature
Maximum power ≤80W
Work flow 3-5S
Working temperature -20~60℃;10~90%RH