Skip to content

iFlight iPower GM4108H Gimbal Motor w/ AS5048A Encoder/ Alexmos 32BIT BGC set

by iFlight
Sold out
Original price €0,00 - Original price €0,00
Original price €0,00
€544,99
€544,99 - €544,99
Current price €544,99

free return

Do you live in Belgium or The Netherlands? Then you can return your package for free!

Out of stock
Description
Description
  • Encoders are special sensors that are added to each brushless motor of a Gimbal stabilizer, allowing the system to more accurately track motor position for greater stability, which in turn also increases battery efficiency.
  • What is encoder technology in brushless gimbal control system?
  • The 3-axis gimbal stabilization system that relies on both active motor-driven components and passive inertial stabilization. Passive stabilization is based on the principles of inertia (the tendency of an object to resist change in its motion) and requires the camera to be well balanced in the Pan, Tilt and Roll axes. Active stabilization refers to the techniques of using sensors to measure the Pan, Tilt and Roll movements of the camera and counter these movements using motors attached to the 3 axes.

Characteristics
  • Easy to do gimbal tuning, no need to calibrate much anymore.
  • Energy saving, 5 times long working time than gimbal without encoder system.
  • Dual IMUs.
  • Faster response, motor torque increases instantly, no more bug for difficult turning angle.
  • Encoderchip A5048a
Model GM4108H
Motor outside diameter Ф47±0.05mm
Engine height 32.3±0.2mm (Incl. met encoderbehuizing)
Hollow Shaft(OD) F10-0.008/-0.012mm
Hollow Shaft(ID) 8+0.05/0mm
Wire length 265±3mm
AWG cable #24
engine weight 137±0.5g
Wire plug 2.5mm dupont-connector
No load current 20V
No load voltage 0.07±0.1A
No tax touring 513~567 RPM
Load current 20V
Load voltage 1.5A
Load torque (g) 1200-1800
Motor internal resistance 11.1Ω±5%(Resistance varies with temperature)
High voltage test DC500V 1mA@2sec
Rotor housing spout ≤0.1mm
Steering direction (axle extension) Clockwise
High-low temperature test
High temperature Stay at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
Low temperature Stay at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
Maximum power ≤25W
Work flow 3-5S
Working temperature -20~60℃;10~90%RH

 

What is included

  • 3 x GM4108H-120T gimbal motor with AS5048A encoder and magnet
  • 1 x Alexmos 32BIT BGC Board Encoder Version without Aluminum Case
  • 1x Set of connection cables