INJORA +4mm Diamond Axles for Traxxas TRX4M 1/18

Note

• Not compatible with the standard TRX4M chassis, because the servo mount is wider than the standard chassis.
• Not compatible with original TRX4M dogbone axles, as the axle housings are extended by 4 mm on each side.
• Compatible with both INJORA and standard TRX4M upgrade parts: gears, C-hubs, knuckles, chassis links, drive shafts.
• Compatible with the following servos: Injora 7 kg servo INJS2065 (add the bushings), Injora 11 kg servo INJS11

Features

• Diamond-shaped pumpkin for a more realistic scale appearance.
• Equipped with a servo-on-axle servo mount that lowers the center of gravity.
• 2 short tie rods optional.
  Pre-assembled complete axles. Grease the axles before installation.
• +4 mm axles increase the width on each side by 4 mm and the total length by 8 mm.
• The entire axles are extended, not just the dogbone axles, preventing overload of the dogbone axles.
• The 4 mm extended design provides better stability and climbing performance.
• Comes with hardened CVD axles, steel 12/24T gears, 5 mm (+1 mm) brass wheel nuts and nuts.